FRP Water Tank Installation

Saturday, April 21, 2012 · 1 comments
Below is guidelines on how to install FRP water tank especially when the installation is to be made within room or constraint space.
  1. For construction of plinth - Please study carefully how big the FRP panel is. 1.0m  or 1.2m.
  2. After confirmation on panel size, setting out to be carry out by taking the following as a guidelines.
  • Clearance between panel to wall. A minimum of 750mm space shall be available for maintenance purpose.
  • If 2 water tanks to be installed, please consider maintenance space of at least 600mm. Normally balancing pipe will be installed. Please refer to Figure 2 below. Due to lack of coordination between C&S and M&E drawing, plinth was constructed too close without considering space between 2 tanks.
  • Separation between 2 plinth is 900mm while FRP panel size is 1000m width. From Figure 1, panel is not sitting at the center of the plinth.
Please take note that photos below indicates POOR PLANNING and POOR COORDINATION of works between C&S and M&E.

 Figure 1

 Figure 2

For detail of installation, please consult with tank supplier or web surf to manufacturer website. Some of them are Pipeco and Myui Fatt. Let Mr Google assist you.

Total Pageviews

 

SKY DASHBOARD | Copyright © 2009 - Blogger Template Designed By BLOGGER DASHBOARD